Cisco SP Optical Technology Field Engineer Representative 500-210, this is a tough exam. If you want to get certified, then please take my advice.
How do I get SP Optical Technology Field Engineer Representative status?
About the introduction of the exam, I will not say. You can refer to here. Take the Cisco 500-210 exam, which is 75 minutes long and has around 45-55 questions. Once you’re done, you’re certified when you receive a success email. You are now the SP Optical Technology Field Engineer Representative.
So, next, you must be asking how to pass the Channel Partner Program 500-210 exam?
You can get the latest Cisco 500-210 exam dumps pdf >>> https://www.pass4itsure.com/500-210.html (500-210 exam practice test questions total), use the exam practice test, test yourself, improve your abilities, and achieve the ultimate success of channel Partner Program certification.
Practice the Cisco 500-210 exam test
QUESTION 1 #
During Automatic Node Setup, if cards are not already installed, what will the setup tool do during slot setup?
A. abort the procedure and restart
B. skip over the empty slots and proceed to the next step
C. return an error message, disconnect, and restart
D. pre-provision the slots with the appropriate card
Correct Answer: D
QUESTION 2 #
In a mesh ROADM node, how many degrees is an omnidirectional add/drop unit accessible from?
A. 1 degree
B. 4 degrees
C. 16 degrees
D. all degrees
E. multidegrees
Correct Answer: D
QUESTION 3 #
In which three configurations can NCS 2000 100G line cards be used? (Choose three.)
A. muxponder trunk
B. 10G transponder
C. 100G regenerator
D. 40G transponder
E. 200G transponder
F. 100G transponder
Correct Answer: ACF
QUESTION 4 #
Which option describes the purpose of the USB ports on the external connection unit of the NCS 2006?
A. to charge a USB powered device
B. load software via a thumb drive
C. inventory and monitoring of passive optical devices
D. multi-shelf management
Correct Answer: C
QUESTION 5 #
Which two methods can be used to start Cisco Transport Controller? (Choose two.)
A. web browser
B. Telnet
C. StartCTC application
D. FTP
Correct Answer: AC
QUESTION 6 #
Between which types of endpoint are optical channel client connections made?
A. wavelength add/drop ports
B. transponder client ports
C. transponder trunk ports
D. optical service channel ports
Correct Answer: D
QUESTION 7 #
Which three types of 100G client pluggable optics are supported on the NCS 2000? (Choose three.)
A. CXP
B. GBIC
C. CPAK
D. CFP
E. XFP
F. SFP
Correct Answer: ACD
QUESTION 8 #
Which two options are the two basic building blocks of the mesh patch panel? (Choose two.)
A. MF-MOD-DEG-5
B. MF-1×16-COFS
C. MF-4×4-COFS
D. MF-MOD-UPG-4
Correct Answer: AD
QUESTION 9 #
In which type of configuration are the MD-48 add/drop modules unusable?
A. colorless
B. omnidirectional
C. 2-degree
D. multidegree
Correct Answer: A
QUESTION 10 #
How many 50 GHz channels does the 16-WXC-FS support on each port?
A. 96
B. 88
C. 80
D. 40
Correct Answer: A
QUESTION 11 #
How many shelves can be subtended from a node controller shelf in an NCS 2006 multi-shelf configuration?
A. 2
B. 3
C. 0
D. 6
Correct Answer: B
QUESTION 12 #
Which two options are the two modes of operation for the 10 port SFP+ line card? (Choose two.)
A. 10 x 10G muxponder client for 100G line card
B. wire-speed encryption
C. 5 x 10G transponder
D. dispersion compensation
Correct Answer: AC
QUESTION 13 #
Which document do you refer to for information about procedures (release 10.0 and later)?
A. Getting Started Guide
B. Reference Guide
C. Configuration Guide
D. Upgrade Guide
Correct Answer: C
QUESTION 14 #
In an NCS 2006 multi-shelf configuration, what is the name of the shelf that holds the node configuration?
A. primary shelf
B. master shelf
C. subtended shelf
D. node controller shelf
Correct Answer: D
QUESTION 15 #
Where within Cisco Transport Controller can the user view the software release level for all nodes in the network?
A. Shelf? Maintenance? Software
B. Node? Maintenance? Software
C. Network? Maintenance? Software
D. Shelf? Maintenance? Wavelength Power
Correct Answer: C
Free Cisco 500-210 exam dumps pdf sharing
Cisco Channel Partner Program 500-210 pdf [drive] https://drive.google.com/file/d/1BnMPc8SORVG751sNQJSAKnI87MIpLi-V/view?usp=sharing
We all know that there are many benefits to obtaining Channel Partner Program certification, and the key is how to get it. Follow my advice and I’m sure you’ll get it.
The full Cisco 500-210 exam dumps pdf https://www.pass4itsure.com/500-210.html helps you.
Hurry up and practice the 500-210 exam questions.
Anyway, I hope this helps anyone who is interested.
Thanks,